listed is a 20 inch aluminum rip fence and guide rail for a vintage craftsman table saw. only rip fence and guide rail that is on one side of whole saw pictured. this auction is for rip fence and rail only. i shown pictures of the whole saw so you’ll be able to see it and if you have an interest in whole saw, contact me and make an offer. it works great. it has a 1/2 hp motor with power bar on both sides of motor. it is on a wooden table with wheels, and the way it is wired is motor plugs into the side 2 outlet electric box that has a switch, which can be used to turn on & off the saw, or you’ll be able to use switch right on motor. the motors number is 115.7556 and works great. than there is an extra outlet in the outlet box for anything else you would have to plug in, it looks find it irresistible came on this table , but i don`t think it did. but it looks and works great on this table and with the wheels , it makes it easier to move by yourself. i can sell whole table saw or just rip fence and guide rail, which is what this auction is strictly for. but i show it all in case you wish to have any other parts, as this is complete , and make me an offer and i can piece this out. please ask questions before bidding and no international bidders. i’m really not sure exactly where these rip fences are measured from, the 20 inches is the size of the cast iron table , of the table saw. if you wish to have any other measurements, please ask, i can gladly get them for you. if you wish to have whole table saw, it is going to should be local pickup. i am in northeast philly area, also right near bridge into trenton new jersey.